How to Build a Ram from a Bag of Plastic

Building a ram from a bag of plastic isn’t too difficult, but it takes a bit of time and skill to make.

To get started, you’ll need to gather some materials, a box of construction paper, and a few sheets of cardboard.

After assembling the necessary parts, you can fill the cardboard box with cement, water, and other materials to create a sturdy ram.

A lot of this will depend on your construction kit and materials.

For example, if you’re building a concrete house, you might want to make sure you’re using a good quality cement.

A cement box should be at least 8 inches long and 6 inches wide, with a diameter of at least 1.5 inches.

You’ll also need a ram that’s a bit smaller than the box, and at least 3 inches high.

If you’re constructing a brick-and-mortar building, you may need a little bit more material.

You can use cardboard boxes for a smaller construction kit, but you’ll probably need to cut the cardboard in half.

Make sure to use a large enough piece of cardboard to accommodate the ram’s width.

Here are some quick instructions for building a ram with a construction paper: 1.

Start by filling your construction paper with a mixture of lime, concrete, and sand.

Lay the construction paper on the surface of the cardboard and secure it with tape.


Using a sand hammer, punch a hole through the paper, filling the paper halfway with the cement.


Now use a piece of sandpaper to smooth the surface, then sand the concrete, which should feel very smooth.


Once the concrete has hardened a bit, carefully drill a hole in the top of the paper.


Then attach the ram to the paper with the construction wire.


The ram should stick to the cardboard.


Using the paper’s adhesive, attach the cardboard to the ram, making sure to secure the cardboard with tape as well.

You should have something like this when you’re done: You can build the ram in about an hour.

For best results, fill your construction box about 2 inches deep and 3 inches wide.

Make your first cut using the cardboard, then build the inside out.

For more tips on building a new ram, visit the official building site.